I found a video on YouTube that shows how to build an oxy-hydrogen generator from scratch using stainless steel plates, acrylic tubing, ABS fittings, poly tubing, and potassium hydroxide. The generator uses electricity to split water into a highly explosive gas that can be used as a fuel. The video also explains how to make a bubbler to filter and store the gas, and how to connect the generator to a power source.
I hope this helps! A list of What Was Used in Video..
- 4” ABS clean out fittings
- 3/8” Poly Tubing
- 100 grit sandpaper
- Rubber Mallet
- ABS Cement
- 1/4” 90 degree Elbow
- 1/2” drill bit
- 18 Thread TAP
- Pipe Tape
- 3/8” Swivel Elbow
- 5/16 drill bit
- Bench vice
- Stainless steel jam nuts
- Acrylic glue
